Minisport

4 SYNCHRO PARTS & BEARINGS- PRE A+ (Up to 1979) with 14MM Nose Mainshaft

Pricing:
Sort by:

MINI & MOKE PINION "C" SHIM .004" - GUG705646GM

GUG705646GM- PINION "C" SHIM .004"

The shims go against the mainshaft double roller bearing securing cap in your gearbox to give it pre load. See workshop manual for advice but you are aiming for only 1 thou pre load.

$4.50
($2.99 USD ) In stock

MINI & MOKE ENGINE TO GEARBOX NUT AND BOLT KIT - MSSK060

MSSK060- MINI & MOKE ENGINE TO GEARBOX NUT AND BOLT KIT

Complete nut, bolt and washer set for engine to gearbox only.

$18.14
($12.04 USD ) In stock

SPEEDO DRIVE PINION 18 TEETH-SPI 3.2 final drive - TXD10006

TXD10006- SPEEDO DRIVE PINION 18 TEETH-SPI 3.2 final drive

Grey colour although some were red 18 tooth (18.8mm diameter) to go with the 7 tooth Red colour coded drive spindle TXF10004 which is 23mm in diameter- as opposed to DAM6028 @21.37mm wide (21.1 WORN) which is also 7 teeth-----Beware also of red colour plastic pinions DAM6365 from Metro boxes which were red (21mm diameter) SO NOTE-TXF10004 and TXD10006 were a special pairing.

Used in 3.2 diff ratio SPI gearboxes which were different to metro equivalents which had 13" wheels.

$72.68
($48.25 USD )

OUT OF STOCK

MINI & MOKE 5/16" CLUTCH CASE STUD SHORT (3 REQUIRED) - 53K547

53K547- MINI & MOKE 5/16" CLUTCH CASE STUD SHORT (3 REQUIRED)

Stud to hold the clutch case to the engine and gearbox, 3 of required. 5/16"UNC thread for alloy fitment for gearbox with UNF thread the other end for the nuts. These are 1.5"long. The 6 longer ones are 22A152. These studs are also used as manifold studs on Mini spares alloy heads. Sold individually.

$3.59
($2.38 USD ) In stock

MINI & MOKE 5/16" THERMOSTAT HSG/GEARBOX TO FLYWHEEL CASE STUD (2.25" long) - 22A152

22A152- MINI & MOKE 5/16" THERMOSTAT HOUSING STUD (2.25" long)

2.25" long universal stud 5/16"UNC one end and unf for the nut end. This fits the gearbox to flywheel case (6 of) and inlet manifolds to take HIF carbs when large spacer fitted.

$4.50
($2.99 USD ) In stock

1/4" UNC BOLT- 3/4" LONG - GHF160

GHF160- 1/4" UNC BOLT (3/4" LONG)

This is the bolt used to hold the throttle bracket (AEG349) onto the manifold and for holding plate on speedo drive housing on gearbox.

$1.41
($0.94 USD ) In stock

DETENT SPRING FOR MAGIC WAND/REMOTE - 2A3647

DETENT SPRING IN THE GEARBOX ON PRE ROD TYPE GEARBOXES (WAND AND REMOTE ONLY).

$2.68
($1.78 USD ) In stock