Minisport

Engine parts/accessories

Pricing:
Sort by:

MINI & MOKE BLOCK BANJO BOLT FOR OIL PIPE FEED LINE (MUST HAVE BANJO TYPE PIPE) - 2A715

2A715- MINI & MOKE BLOCK BANJO BOLT FOR OIL PIPE FEED LINE

The engine block union bolt that holds the oil fed pipe from the filter on all A series engines (must have the pipe to suit the bolt)

$36.32
($24.69 USD ) In stock

OIL TRANSFER PIPE TO BLOCK FILTER HEAD SEAL 1992 12A ENG (ROVER) - LZB10017

LZB10017- MINI & MOKE BLOCK BANJO BOLT FOR OIL PIPE FEED LINE

From 1992 the 1275cc engines had these seals on either end of the block to filter feed pipe.Under arduous/severes conditions these and the olives ends have been known to pop out and many owners change to a solid end stainless steel covered pipe MOC1018

$11.77
($8.00 USD ) In stock

MINI & MOKE ENGINE TO GEARBOX NUT AND BOLT KIT - MSSK060

MSSK060- MINI & MOKE ENGINE TO GEARBOX NUT AND BOLT KIT

Complete nut, bolt and washer set for engine to gearbox only.

$18.14
($12.33 USD ) In stock

MINI & MOKE ENGINE NUMBER RIVET (WHEN PLATE IS FITTED) - 2A895

2A895- MINI & MOKE ENGINE NUMBER RIVET (WHEN PLATE IS FITTED)

This is the rivet that secures the engine plate onto the engine. This wasn't used on all engines. Blank engine plate is also available (CP343) & can be reversed stamped if required. 2 required per engine.

$1.77
($1.21 USD ) In stock

ROVER MINI BLANK ENGINE NUMBER ID PLATE (WHEN PLATE IS FITTED) - CP343

CP343- ROVER MINI BLANK ENGINE NUMBER ID PLATE (WHEN PLATE IS FITTED) 68.24mm

This is the plate for your engine number. This wasn't used on all engines. Rivets are also available (2A895). This plate can be reversed stamped if required. 1 required per engine. The distance from hole to hole is 68.24mm

$5.41
($3.68 USD ) In stock

MINI & MOKE ENGINE BREATHER EARLY TYPE- STAINLESS STEEL TYPE - SMB175

SMB175- MINI & MOKE ENGINE BREATHER EARLY TYPE- STAINLESS STEEL TYPE

This is a stainless steel version of the original engine breather (upright) type. This fits on the clutch housing & you will need to have the threads and the hole in the housing- This can be done if you have the landing to suit.

$177.27
($120.52 USD ) In stock