This is a generic heater tap that was fitted to the cylinder head on the classic mini & moke. These were also fitted to many other A series.   

The original RANCO tooling has been scrapped so beware of some imports available where the inners quickly explode loosing the metal cap and all your water when operated. This has M4 metric thread bolt included...

This heater tap was fitted to the heater of a mini clubman and sits down near the floor on the passengers side, if you heater in the clubman doesn’t work then chances are this is...

C-ARA3002- UNIVERSAL HEATER TAP- 1/2"(13MM) HOSE- PULL TO OPEN This is a fully serviceable universal heater tap. The hose diameter it suits is 1/2 inch or 13mm. This setup is cable operated and is supplied with a...

C-ARA3004- UNIVERSAL HEATER TAP- 1/2"(13MM) HOSE- PUSH TO OPEN This is a fully serviceable universal heater tap. The hose diameter it suits is 1/2 inch or 13mm. This setup is cable operated and is supplied with a...

[JJB10011] From 1989 until the introduction of the twin point injection cars, Rover fitted this in line floating heater valve which was the first time they never bolted the heater valve as a direct outlet on...

Twin point Mini heater tap that fits to the heater assembly.

This is the thin paper type gasket that goes between the heater take off and the head on almost all mini or mokes. For the upgraded thicker type see 88G221

This is the gasket that goes between the heater take off and the head on almost all mini & moke heads. This is the thick type gasket.

Heater tap fitting kit comprising of studs, nuts, plain washers, spring washers and a gasket. Kit includes: 2X 53K402- HEATER TAP STUD 1X 88G221- HEATER TAP GASKET 2X GFK1124- 1/4" SPRING WASHER 2X GFK3211- PLAIN...

SMB119- MINI & MOKE HEATER VALVE BLANKING PLATE FOR CYLINDER HEAD- STAINLESS STEEL   Use this plate in place of the heater valve. For use any time the heater is removed! Stainless steel with bolts &...

2A180- MINI & MOKE HEATER VALVE BLANKING PLATE FOR CYLINDER HEAD   Use this plate in place of the heater valve. For use any time the heater is removed!

This heater take off pipe fits on the cylinder head of your mini engine- Only available secondhand they all have signs of wear & corrosion BUT with a bit of silicon these are more than useable. 

This a stainless steel heater take off pipe fits on the cylinder head of your mini engine, brand new with stainless bolts, gaskets and washers supplied (as shown) 

12G2534- MINI & MOKE HEATER TAKE OFF PIPE- 5/8" HOSE (ROVER TYPE) Once the old type alloy heater valve on the head was discontinued in 1990 for the plastic free floating inline type this take off...

53K402S- MINI & MOKE HEATER TAP STUD- STAINLESS STEEL Stainless steel heater tap stud for the cylinder head. This is 1/4" UNF. Matching stainless steel nut is GFK3211S

GFK3211S- 1/4" UNF NUT- FINE THREAD NUT- STAINLESS STEEL Stainless steel 1/4" UNF nut for the heater tap stud (53K402S). This is 1/4" UNF.

ALA6592- MINI OR MOKE FIREWALL BRACKET- ONE HOLE Blank plate on bulkhead with one hole for a single heater hose. There are 3 types (ALA7530 with holes) or (ALA6592 with one hole) or (ALA6593 blank no holes).