This is the standard non ballast coil as used on the late Mini with factory electronic ignition for use with 65D distributor 0.9ohms.  GCL143 was the Genuine Rover part fitted part on 1275cc from 1990....

GCL204- ROVER MINI COIL PACK FOR MPI - TWIN POINT 1996 ON A complete break from the original looking coils this is only for use on twin point injection cars.

Introduced by the factory to eradicate water getting to the electric coils causing breakdowns this was used up until they introduced the plastic engine protection shield but many owners still played safe and fitted one...

SMB28- MINI & MOKE COIL MOUNTING BRACKET- STAINLESS STEEL This is a really nice stainless steel coil bracket that attaches to the head stud. It is made for a horizontal mount coil. Will fit almost ANY...

8B12398- MINI & MOKE COIL MOUNTING BRACKET & COIL COVER- STAINLESS STEEL This sleeve fits most Lucas and Unipart coils to give the impression thay are stainless steel. Comes with a s/steel bracket. Covers just over...

12H51- MINI & MOKE GENERATOR MOUNTED COIL BRACKET (A SERIES) This is the early generator bracket that supports the coil on top of it. As fitted to many A series and other brittish cars that used...

These are a set of points to suit the 23D, 25D & 29D distributor. These points 'bolt on' to the condenser with a nut. Matching Condenser is 47H5250. These were fitted up to about 1974...

Original Lucas type 2 piece contact set made for the non vacuum type distributor fitted to original Cooper S with a stronger 32oz spring.

These points were fitted from 1974-80 when the distributors became a 43D or 45D type, the distributor cap shape changed also to GDC136 and like wise rotor arm GRA2114 and condenser GSC2109. Factory points gap...

These points were fitted into mokes around 80-81, you may however find these installed into other cars where the dissy has been changed. original part number was RTC6627.

Condenser to suit early 60's distributor, If you have points that have a bolt on the side of them these are the ones you will need.  Alternative Part number: 33710

RESIN BASED CONDENSER as per the original Lucas type made for the 23/25D type distributor as fitted to original Cooper S or Racers who want a trusty part or where originality is required,with soldered wire...

Clip on condenser to suit 70's dissy, If you have points that have a clip on the side of them these are the ones you will need. Old part number was 33720Alternative part number(s): 33720,...

Original Lucas type RESIN BASED CONDENSER made for the 45/59D type distributor if you want a quality item rather than the cheaper inferior parts available. Filled with 3m of winding inside as per original Lucas...

Swiftune has developed an all-new Competition Condenser for ALL engines running with conventional ignition points. The Swiftune condenser replaces the existing Lucas unit which have proved increasingly unreliable in recent years due to poor quality. Increasing the...

Fitted to ducellier distributors only These are Recognised by their red cap. Please note that these are NOT for standard Australian cars

This "Pigtail" wire is all that carries current through the distributor to the points. Fits 23 and 25d type distributors

This is a simple screw in points replacement kit made for the late (43D/45D/59D) clip on points setup... great value! simple to install. Supplier notes: "These units are factory tested. Used correctly they do not...