This switch was mainly used on the dual stalk 1980+ mokes and many imported rover models. This switch uses the 37H8285 wiper sitch for the wash/wipers. This combination willl give you the indicators on the...

This switch was usually fitted in Australia on the dual stalk 1980+ moke. This was also fitted to the imported rovers where the indicators were on the right & the wipers were on the Left....

Spin on oil filter from the original suppliers as designated and approved by Rover/Unipart until 2014. Original filter for twin point injection cars where it screws directly into the block. See GFE210 for shorter filter when optional oil...

KTP9002- ROVER MINI FAN SWITCH RETAINING CLIP IN RADIATOR (1992 ON) From 1992 mini radiators were fitted with a push in thermal transmitter GVS104 and this is the clip to hold it and the seal in...

The original factory radiators had a seal to hold the switch in but on our special 2 core and 4 core radiators we used this screw in type switch for extra safety. Already fitted to...

PAM1015- ROVER DOOR MOULDING OUTER WITH SEAL- L/H L/H outer brightwork trim with the seal attached to stop water seeping down into the door frame, on all UK cars with FULL wind up windows from about 1980 on, these are...

These were first used on the one piece cowling from 1974 on. These go on the lower retaining  bolt.  Sold single- 2 required per car.

Standard upper front subframe mount. If you have a late model Mini rover (1976 on) then you probably know that the front subframe is isolated by these rubber mounts. While this makes the car quieter,...

GRH1242- RADIATOR LOWER HOSE FOR SINGLE POINT INJECTION Rubber lower radiator hose for the single point injection cars only. Heater pipes run as follows heater to bottom hose heater to valve-valve to thermostat via PCH10532...

[MK5995] This switch will replace your rotary wiper switch on your moke. It is a Lucas switch and looks original. We have wired this up to work in place of the old wiper rotary switch (no...

12G2621- TIMING CHAIN TENSIONER PAD (A+ SINGLE ROW) Plastic tensioner pad to take up the slack in single row timing chains on A plus engines that wears ans should be replaced nearly everytime you have...

LIGHT SWITCH, MK4 FROM 1976. ROCKER TYPE (SMALLER THAN MK3 TYPE, ALMOST SQUARE). WITH PIN CONNECTIONS.

[12A2153] This lower radiator bracket originated when the one piece rad cowling was introduced. Not fitted to our Australian cars (ROVER ONLY) or cars with the one piece covers fitted.

PAM1014- ROVER DOOR MOULDING OUTER WITH SEAL- R/HR/H outer brightwork trim with the seal attached to stop water seeping down into the door frame, on all UK cars with FULL wind up windows from about 1980 on, these are the...

YUF101660- MINI 'ROVER' SWITCH FOR HAZARD WARNING HAZARD WARNING SWITCH, PIN TYPE CONNECTORS.MK4 FROM 1976.3.1cm tall

PFR109- RETAINING CLIP & FIXING CLIP FOR ROVER MINI BARREL LOCK & 24A71 BADGE Clip for ROVER Door Handle required when changing barrel set. Heavy duty round spire clip specially made for the job.

Fitted from 1988 on this master cylinder had a built in servo. This was used right up to the last production twin point vehicles from rover. see GSM119 and 120 for servo fitted to this.

Fits on the back of the engine as a fuel trap intake. Fits single point injection cars only.